How to Perform Hard Reset on Netgear Range Extender
Do the
users of Netgear extender see orange or amber light blinking? Do the users want
to reset the password and settings of the range extender? These are some
problems that have been encounter every day by the users of Netgear range extender. So how to remove these problems or what troubleshooting
steps should be followed to remove these technical problems of Netgear extender
have been discussed in this article.
To
tackle the above problems just restore Netgear extender to factory default
settings. There are two ways through which this can be achieved. i.e Hard reset
or Soft Reset. The hard reset method has been explained in this article below.
Troubleshooting Steps of Hard Reset method:
There have been
small mistakes that have been done by many users while resetting the extender.
So careful steps should be taken while it is in turn off mode.
·
Paper clip material has been preferred while resetting the extender
·
Just by looking of the backside of extender user will find a reset
hole, press it with the paper clip
·
Hold the reset button for 30 seconds or else user of Netgear extender
will saw all light blinking in extender
·
After the resetting button for 30 seconds rebooting process will start
automatically in Netgear extender.
·
All the settings have been restored successfully in the Netgear
extender. Set up the router now by visiting the official website i.e. www.mywifiext.net.
So by following these troubleshooting steps, the hard reset method can
be achieved easily. But still, if some problems exist while resetting or in
setting up Router then the Netgear wifi Extender Setup team
is there to help you out. We have a certified team of technicians that will
help you out anytime i.e. 24 x 7.
Comments
Post a Comment